First Impressions: Paul Component Tall & Handsome Seatpost

Over the past couple of years, I’ve been on a Goldilocks-like search for a seatpost that was just right.  Some posts had plenty of offset, but were difficult to adjust.  Others could be easily adjusted, but their tolerances were inconsistent.  Frustrated with seatposts that were lacking in one way or another, I decided to try the Tall & Handsome seatpost from Paul Component Engineering.

GRAVELBIKE.com Paul Component Engineering Tall & Handsome seatpost Selle An-Atomica

Unlike most forged alloy seatposts, the Tall & Handsome’s shaft and head are machined from two separate pieces of 2024 aluminum alloy. The offset, two-bolt head is bonded and screwed into the precision-ground shaft.  While this may not result in the lightest post on the market (the T&H weighs 320g), my digital calipers revealed a consistent 27.2mm diameter over the usable length of the shaft.

GRAVELBIKE.com Paul Component Engineering Tall & Handsome seatpost Selle An-Atomica

The two-bolt clamp can be adjusted to +/- 7.5°.  The clamp’s two bolts sit on spherical washers, which allows the hardware to self-align with the clamp/cradle assembly.  Setting my saddle’s angle was a breeze, and once it was dialed-in, the clamp remained secure (and silent) over bumpy dirt roads and trails.

Riders who are looking for additional setback will be well served by the Tall & Handsome’s 26mm offset.  An added benefit of the dual, separate upper clamps is that the effective setback is increased by another couple of millimeters (while the 40mm lower clamp still offers plenty of rail support).

Paul Component Engineering offers the Tall & Handsome only in 27.2m diameter (length is 360mm).  Suggested retail price is $112 for black or silver anodized finishes, and the polished silver version sells for $118.

3 thoughts on “First Impressions: Paul Component Tall & Handsome Seatpost

    • My experience with the VO post is limited to a single seatpost that I used approximately three years ago. My post was slightly undersized (with an inconsistent OD, to boot), and would not stop slipping. There was also an issue with the clamp/cradle design where the nose of the saddle could not be angled down enough. Since then, I’ve used seatposts from Kalloy/Uno, Ritchey, and Titec with better results.

What's on your mind?